Hioki 8420-51 - Page 45

3.3 Integrating the Pulse Output from a Power Meter
41
1
2
3
4
5
6
7
8
9
10
5
Set the display area to "Posn&Zoom."
Move the blinking cursor to the position shown.
Select "Posn&Zoom."
Set the input type (Mode) to "Count."
Move the blinking cursor to the position shown.
Select "Count."
Set the range to "2500Mcf.s.."
As 1 kWh is 50,000 pulses, the Memory HiLogger can measure
up to a monthly total power level of 50,000 kW.
Move the blinking cursor to the position shown.
Select "2500Mcf.s.."