44
3.3 Integrating the Pulse Output from a Power Meter
Quick Start Manual
When scaling is selected, measurements will be read
directly in kWh units.
Set the scaling.
Move the blinking cursor to the position shown.
Set the scaling method to "TYPE 2."
Move the blinking cursor to the position shown.
Set the scaling unit to "kWh."
Move the blinking cursor to the position shown.
Enter the following:
1 [kWh] = [ 50000.00 ] pulse
❖
See Section 5.4 "Setting Scaling" (page 86) of Instruction Manual.
Upper limit value: 50,000 kWh, Lower limit value: 0
Set the display format to "ENG."
Move the blinking cursor to the position shown.
To Next Page
Loading...
