- 2 -
2. Parts of Names
Note:
①
The design of bit-guide has been changed form V-type to bowl-type since September,1998.
However, the operation method is same as the former V-type , therefore, the descriptions and the drawings for the V-
type are still used in this manual. Pleas be careful that the bit type have been changed.(See p.11)
②
A drop preventive plate is provided in this machine. However,, this part should not be touched or maintained by users,
consequently,theexplanationsandthedrawingsforthispartareomittedinthismanual.
Screw bin lid
Power switch
Timing shaft ac-
cess hole
Rail screw access hole
Stopper
Rail
Rail assembly
Sensor Brush
Timer setting control
access hole
Slant screw access hole
Slant screw access hole
Bin dipper plate
Screw passage plate
Shutter (in front of screw pas-
sage plate)
Screw bin
DCjack
Bin dipper plate
Bit guide
Holding plate
Bit guide unit
Screw bin
Bowl type
Fig. 1
Passage window (passage
plate screw passage window)
Passage plate
lock screw
ET-D003_15A.indd 2 2015/02/17 13:39:58
To Next Page