HIOS HS Series - Page 4

- 3 -
3. Before use
3-
1
. Check screw type
Before operating HIOS your screw feeder, make sure You can
easily replace the rail unit to match the diameter of the screw
you wish to use.
Check the screw number shown on the front of the rail unit to
make sure your using correct diameter screw.
Beforeoperation,adjustthefollowingaccordingtothescrewtype
to be used.
Beforeoperation,adjustthefollowingaccordingtothescrewtype
to be used.
○Brush
○Screwpassageplate
○Bitguideunit
○Railunit
CAUTION: Be sure to turn off the power switch of the feeder
beforemakinganyadjustments.
Operation screw
dia. Nominal
Model
M2.6 HS-26
M3.0 HS-30
M4.0 HS-40
M5.0 HS-50
Fig. 2
Fig. 3
Ｒ ３ ０
Screw No.
Be sure to turn off the power switch of the feeder
beforemakinganyadjustments.
Check the height of the brush
where is in horizontal ;position
Hexagonalwrench
Timing shaft access hole
Rail unit
ET-D003_15A.indd 3 2015/02/17 13:39:59