Need help?Do you have a question about the HIS H10 000 and is the answer not in the manual?
General| Category | Tools |
|---|---|
| Type | Barcode Scanner |
| Model | H10 000 |
| Decoding Capability | 1D |
| Compatibility | Windows, Linux, macOS |
Allows operator full control of pulling rope, reduces overlap, and ensures safe zone operation.
Features a two-speed motor with low (12 ft/min) and high (24 ft/min) speeds.
All components built-in for reduced setup time, convertible from 3 to 2 section frame.
Includes standard conduit adapters (2-5 inch) and a 6-inch combo adapter/yoke.
Specifies maximum pulling capacities: 4,500 lbs (high speed) and 10,000 lbs (low speed).
Covers essential safety guidelines, warnings, and hazard zone awareness.
Details required inspections of the puller, rope, and work area before operation.
Provides instructions for safely securing and moving the cable puller.
Lists crucial pre-setup checks including equipment, area, protective clothing, and power.
Guidance on selecting and fitting the correct conduit adapter for the duct or conduit.
Steps for threading the pull rope through the adapter/yoke and attaching the yoke.
Instructions for positioning the puller frame and routing the rope over sheaves correctly.
Method for wrapping the pull rope clockwise around the capstan to increase pulling capacity.
Final checks of power supply, components, and setting the puller speed for operation.
Important notes on using a safety chain and switching speeds based on load.
Steps for threading rope, extending arms, adjusting wheels, and securing the yoke.
Instructions for wrapping the rope on the capstan and setting the motor to low speed.
Guidance on operating the footswitch, maintaining a safe angle, and managing rope feed.
Steps for unwrapping the rope, disengaging the arm, and storing the puller after use.
Details the manufacturer's warranty for the HIS Cable Puller H10,000 against defects.
Provides fields for recording purchase date and serial number for warranty purposes.
To Next Page