Need help?Do you have a question about the Hisense ACT-09UR4RCA4 and is the answer not in the manual?
General| Cooling Capacity | 9000 BTU/h |
|---|---|
| Refrigerant Type | R410A |
| Power Supply | 220-240V, 50Hz |
| Type | Split System |
| Operating Temperature (Cooling) | 18°C to 43°C |
| Operating Temperature (Heating) | 24 °C |
Provides detailed specifications for Duct type air conditioners.
Details specifications for Cassette type air conditioners.
Provides specifications for Ceiling & Floor type air conditioners.
Lists specifications for Console type air conditioners.
Presents electrical specifications for outdoor units by capacity.
Shows cooling and heating capacity charts for various unit types and capacities.
Displays ESP charts for Duct type indoor units by capacity.
Specifies maximum allowed pipe lengths and height differences for different models.
Details the procedure for performing an air-tight test using nitrogen gas.
Explains how to calculate and add refrigerant based on piping length.
Lists parameters for outdoor compressor discharge temperature sensor.
Provides parameters for other indoor and outdoor unit sensors.
Details fault codes indicated by the wire remote controller and display panel for indoor units.
Provides a table of outdoor unit fault codes, their reasons, and solutions.
Details the process for checking the refrigerant system flow and components.
Provides methods for checking indoor unit fan motors and compressors.
Details the T2 protection logic for evaporator low-temperature in cooling mode.
To Next Page