How to troubleshoot communication trouble between outdoor unit and Hisense AS-13UR4SYDTDI?
If you're experiencing communication trouble between the outdoor unit and your Hisense Air Conditioner, start by checking the connection wires to ensure they are securely connected. If the connections are good, the outdoor board or drive board may be faulty and require replacement.
What to do if my Hisense AS-13UR4SYDTDI shows communication failure between the indoor and outdoor units?
If your Hisense Air Conditioner is showing a communication failure between the indoor and outdoor units, there are several possible causes. First, check the communication cable connection to ensure it is secure. If the connection is good, the cable itself may be faulty and need replacement. Also, inspect the connections between the filter board and both the outdoor control board and the terminal. If these steps don't resolve the issue, the indoor control board, PFC board, power board, or outdoor control board might be defective and require replacement.
What to do if my Hisense AS-13UR4SYDTDI has current overload protection?
If your Hisense Air Conditioner is experiencing current overload protection, it could be due to several reasons. Check the fan motor to ensure it's running correctly. Also, inspect the condenser and evaporator coils to see if they are dirty and need cleaning. Finally, make sure that the air inlet and outlet are not blocked or restricted in any way.
Why does my Hisense AS-13UR4SYDTDI Air Conditioner have maximum current protection?
If your Hisense Air Conditioner is triggering maximum current protection, it could be due to a short circuit. The outdoor control board or the drive board might have a short circuit and need replacement. Alternatively, check for any other components that may be short-circuited and replace them.
What to do if the Hisense AS-13UR4SYDTDI outdoor coil temperature sensor is in trouble?
If the outdoor coil temperature sensor in your Hisense Air Conditioner is malfunctioning, first check the sensor connection to ensure it is secure. If the connection is good, the sensor itself may be faulty and need replacement. As a last resort, the outdoor control board might be the cause of the problem and also needs replacement.
What to do if the compressor exhaust temperature sensor in my Hisense Air Conditioner is in trouble?
If the compressor exhaust temperature sensor in your Hisense Air Conditioner is not working correctly, you should first check the sensor connection to make sure it's secure. If the connection is fine, the sensor itself might be defective and require replacement. Another potential cause is a failure of the outdoor control board, which would also need to be replaced.
Discusses specific safety warnings and precautions for installation and operation.
Detailed specifications for the AS-10UR4SYDTDI model.
Detailed specifications for the AS-13UR4SYDTDI model.
Detailed specifications for the AS-18UR4SFATDI6 model.
Detailed specifications for the AS-24UR4SDBTD16 model.
Guidelines for selecting the appropriate installation location.
Procedures for removing air and testing for refrigerant leaks.
Lists error codes, indications, and potential causes for faults.
General| Refrigerant Type | R32 |
|---|---|
| Weight (Indoor Unit) | 8.5 kg |
| Power Supply | 220-240V, 50Hz |
| Type | Split |
| Energy Efficiency Ratio (EER) | 3.21 |
| Dimensions (Indoor Unit) | 835 x 208 x 295 mm |
| Operating Temperature Range (Cooling) | 16°C to 32°C |
| Operating Temperature Range (Heating) | -7°C to 24°C |
To Next Page