Hisense AS-36HR4SDKDK User Manual

53
34
The failure for
temperature sensor of
indoor coil temperature
a. The indoor coil temperature sensor loose;
b. The indoor coil temperature sensor is failure;
c. The indoor control board is failure.
38
Indoor EEPROM failure
a. The EEPROM chip loose;
b. The indoor control board is failure
39
Indoor fan motor run
abnormally
a. There are something block the indoor fan motor;
b. The fan motor cord connect loose; c.
The fan motor is failure; d. The indoor control
board is failure
41
The failure for Indoor
grounding protective
The indoor control board is failure
42
Overcooling protection
a. It is normally for protection,When the
indoor pipe temperature below T<-1℃(-7℃).Outdoor fan motor and
compressor will stop running. When the Indoor pipe temperature is
higher than -1(-7℃),the unit will restart normally
b. The indoor coil temperature sensor is loose;
c. The indoor coil temperature sensor is failure;
d. The indoor control board is failure.
43
Overheating protection
a. It is normally for protection, When the
indoor pipe temperature between 53℃<T<63℃, the outdoor fan
motor will stop running. When the indoor coil temperature is higher
than 63℃, the error code will display. After the indoor pipe
temperature is lower than 49℃, the air conditioner will restart
normally.
b. The indoor coil temperature sensor is loose;
c. The indoor coil temperature sensor is failure;
d. The indoor control board is failure.
Remark:
The failure is detected when the room temperature sensor broken or shorted over 5 sec.
The failure is detected when the temperature sensor of heater exchange broken orshorted over 5 sec.
The failure is detected when each setting data is not match after the EEPPOM self-check twotimes.
The failure is occur when the grounding signal is not detected after the appliance power ON.

Hisense AS-36HR4SDKDK Specifications

General

Brand	Hisense
Model	AS-36HR4SDKDK
Category	Air Conditioner
Language	English