10
the inlet line of the refrigerator by a
Two-Way Connector. The water line must
be fully inserted into the center of the
connector to prevent water leaking.
Insert the 2 clips in the install pack as
shown in the diagram, and then confirm
that each clip holds the line firmly.
The initial dark discoloration of water is
normal.
The water lines must be connected with
the potable water only.
The water lines should not be pressed by
heavy things and should not bend too
much.
It is normal that there will be sound of
exhaust comes out from the appliance
when you connect the water line to the
appliance and press the level of the
dispenser for the first time.
Warning!
After turning on the water valve, make
sure that there is no leakage at all
connection points of the water lines. If
there is a leakage, turn off the valve
immediately and tighten the water
connector or make the lines fully inserted
into the connector.
The water line must be connected to the
cold water pipe. If it is connected to the hot
water pipe, it may cause the purifier to
malfunction.
Avoid contamination of pipes during
installation.
To Next Page
Loading...
Need help?
General
