Hisense HR6FDFF701SW - Ice Making Process and Troubleshooting

17
Ice is made in
cubes. When
‘Crushed’, the
ice maker grinds the ice
cubes into crushed ice.
When you
select Cubed ice
amount of crushed ice might be produced.

When you select Crushed ice
amount of cube ice might be produced.

The ice cubes generated by the rapid ice
making process will look
indicates they were generated normally.
If ice doesn’t come out,
pull
bucket and press the test button located
on the right side of ice
maker.
ice maker, stay press
ing the test button on
the ice maker for 10
seconds
released it. See
the illustration blow.

Do not press the test button
when the tray is filled with ice or
Water
may overflow or ice may jam the
bucket.
Making ice

To fill the ice bucket to maximum capacity
after installation, follow
these steps:
1. Allow
your refrigerator to operate and
cool down for 24
hours (or
day).Waiting 24 hours wil
l allow your ice
maker to cool properly.
2. Dispense
4 to 6 ice cubes into the glass.
3. After 8, and then 16
hours,
full glass of ice.
Warning!

Do not put food in the ice
store food in the ice
bucket, the
strike the ice maker when you open or
close the door, causing
damage to the ice
maker.
Note
that the ice cubes in the ice bucket
may spill out over the
drawer. If
cubes. When
you select
ice maker grinds the ice
select Cubed ice
, a small
amount of crushed ice might be produced.
When you select Crushed ice
, a small
amount of cube ice might be produced.
The ice cubes generated by the rapid ice
making process will look
white, which
indicates they were generated normally.
pull out the ice
bucket and press the test button located
maker.
To test the
ing the test button on
seconds
before
the illustration blow.
Do not press the test button
continuously
when the tray is filled with ice or
water.
may overflow or ice may jam the
To fill the ice bucket to maximum capacity
these steps:
your refrigerator to operate and
hours (or
1 full
l allow your ice
4 to 6 ice cubes into the glass.
hours,
dispense a
Do not put food in the ice
bucket. If you
bucket, the
food can
strike the ice maker when you open or
damage to the ice
that the ice cubes in the ice bucket
drawer. If
this occurs,
be
sure to clear the ice cubes that spilled
out of the drawer.
If a power failure
occurs, ice
melt, and
then freeze together when the
power comes back
on, causing
dispenser to stop working.
To prevent this
problem, after
failure, pull
out the ice bucket and residual
ice or water.
Note:
Don't push the water
dispenser lever
forward without a cup below since it may
cause water spilling.
Using the ice off function
When you select the ice off
all ice cubes from the bucket.
I
f you leave the ice cubes in the
the ice cubes may clump
together, making
it difficult to remove them.
To remove the ice bucket safely and avoid
injury, hold
the bottom of the bucket with
one hand and the side of the bucket with
the other.
Then, lift up on the ice
bucket, and
straight out in the directio
n of the arrow
To put the ice bucket
in, push
straight back. If
the bucket does not
turn
the helix 90 degree (see the last
illustration on the
right, below) and
again.
Note:

The inside of the ice bucket is very cold
when the
refrigerator is operating.
reach deep inside the ice bucket.

Use only the ice maker provided with the
sure to clear the ice cubes that spilled
occurs, ice
cubes may
then freeze together when the
on, causing
the
problem, after
a power
out the ice bucket and residual
dispenser lever
forward without a cup below since it may
Using the ice off function
When you select the ice off
mode, remove
all ice cubes from the bucket.
f you leave the ice cubes in the
bucket,
together, making
To remove the ice bucket safely and avoid
the bottom of the bucket with
one hand and the side of the bucket with
bucket, and
pull it
n of the arrow
.
in, push
it firmly
the bucket does not
fit,
the helix 90 degree (see the last
right, below) and
try
The inside of the ice bucket is very cold
refrigerator is operating.
Don't
reach deep inside the ice bucket.
Use only the ice maker provided with the
To avoid cold air leaking out from cabinet,
keep the water dispenser parts installed
even if the water dispenser is not being
used..