Hisense HYE-Q01 - Page 110

Wireless Receiver Kit
●
B
A
B
A
Fig. 3
●
●
●
（６）
Ｔｈｅ ｉｎｓｔａｌｌ ｏｆ ｅｘｐａｎｄｅｄ ＰＣＢ ：
Ａｓ ｓｈｏｗｎ ｉｎ ｆｉｇｕｒｅ １ ｂｅｌｏｗ． Ｃｏｎｎｅｃｔ ｔｈｅ ｒｅｃｅｉｖｅｒ ｋｉｔ ｔｏ ｔｅｒｍｉｎａｌ ＣＮ２３ ｏｆ ｔｈｅ ｅｘｐａｎｄｅｄ ＰＣＢ．
ｔｅｒｍｉｎａｌ ＣＮ２３
ｅｘｐａｎｄｅｄ ｐｃｂ
Clamp
ｒｅｃｅｉｖｅｒ ｋｉｔ
torque 0.5N
Inside of electrical box
Outside of electrical box
Fig. 1
As shown in figure 2. In the electrical box there are four spare white supporting feet, arranging for 63 mm × 26 mm
rectangle.Set the extended pcb up to these four white support feet.
Inside of electrical box
Installation holes
support feet
Twisted Pair
Fig. 2
As shown in figure 3 .Connect the bring wiring of the expanded pcb (labeling CN21) to the terminal
CN21 of master pcb.
master pcb
Inside of electrical box
lable
Using clamp tighten twisted-pair .
101