Need help?Do you have a question about the Hisense HZX-4.0AEC and is the answer not in the manual?
Defines DANGER, WARNING, and CAUTION levels for hazard identification.
Specifies the operational temperature limits for cooling and heating modes.
Highlights immediate hazards resulting in severe personal injury or death.
Covers practices that could cause severe or minor injury or damage.
Identifies the Control Box and Expansion Valve Box as system components.
Lists AHU Connection Kit models, their capacities, and related components.
Details the items provided in the package for installation and operation.
Specifies constraints on piping length, elevation, and location.
Guidance on selecting an appropriate heat exchanger for AHU compatibility.
Manages system capacity based on detected room air temperature.
Adjusts capacity to meet a set outlet air temperature target.
Utilizes external signals (0-10V, 0-5V, 4-20mA) to control system capacity.
Describes combining multiple AHU kits for a single large AHU.
Specifies suitable and restricted locations for unit installation.
Provides physical dimensions and mounting details for control and expansion valve boxes.
Details methods for mounting the expansion valve box horizontally, vertically, or suspended.
Instructions for correctly installing air, liquid, and gas pipe thermistors.
Details requirements for selecting and preparing refrigerant pipes.
Specifies correct methods and torque for flare nut connections to prevent leaks.
Ensures proper power supply voltage, wiring, and grounding before connection.
Instructions for connecting wires to the control box, ensuring water protection.
Details specific terminal connections and their specifications for various signals.
Guides on accessing and navigating the remote controller's setting menus.
Procedures for resetting settings and a table of configurable parameters.
Configuration of various input signals for remote control and external inputs.
Details on using remote control, external thermostats, and operation mode settings.
Configuration for picking up system operation and alarm status signals.
Settings for unit number, model code, capacity, and refrigerant cycle on PCBs.
Steps to perform before system operation, including electrical checks and valve opening.
Information on the manufacturer's responsibility and limitations for the AHU connection kit.
To Next Page
General