Hisense RT12A2CSE - Door Seals and LED Light; Replacing the LED Light

the interior is completely dry should the appliance be switched back on and
plugged back into the mains socket.
Door seals cleaning
Take care to keep door seals clean. Sticky food and drinks can cause seals to stick to
the cabinet and tear when you open the door. Wash seal with a mild detergent and
warm water. Rinse and dry it thoroughly after cleaning.
Caution! Only after the door seals are completely dry should the appliance be
powered on
Replacing the LED light:
Warning:
The LED light should be replaced by a competent person. If the LED light is damaged,
contact the customer helpline for assistance. To replace the LED light, the below steps
can be followed:
1. Unplug your appliance.
2. Remove light cover by pushing up and out.
3. Hold the LED cover with one hand and pull it with the other hand while pressing
the
connector latch.
4. Replace LED light and snap it correctly in place.
5. Install the light cover.
16