Leveling of appliance
For sufficient leveling and air circulating in
the lower rear section of the appliance, the
bottom feet may need to be adjusted. You
can adjust them manually by hand or by
using a suitable spanner.
Note:
If required you may lay the refrigerator on
its back in order to gain access to the base,
you should rest it on soft foam packaging
or similar material to avoid damaging the
backboard of the refrigerator.
There is no need to install these
accessories under normal usage.
Only under the extreme circumstances
, cabinet empty while load on freezer door
and fridge door separately with heavy
weight,at the same time opening the two
doors about 90 degree, the refrigerator
maybe lean forward. Then rubber
supporting pad should be fastened to the
lower base cover to steady this appliance.
1. Tilt appliance to find screw hole on the
9
Adjustable bottom feet
left of lower base cover.
2. Put screw into the hole of rubber
supporting pad.
ORZHUEDVHFRYHU
G
VFUHZ
To Next Page
Loading...
