□,
F
Front
□,
R
Rear
d. Place the other end of the hose into a
container.
e. Slowly apply the brake pedal several
times.
f. Push down on the pedal and hold it.
g. Loosen the bleed screw and allow the
pedal to travel towards its limit.
h. Tighten the bleed screw when the pedal
limit has been reached, then release the
pedal.
i. Repeat steps (e) to (h) until all the air
bubbles have disappeared from the fluid.
j. Tighten the bleed screw.
NOTE:
If bleeding is difficult, it may be necessary
to let the brake fluid settle for a few hours.
Repeat the bleeding procedure when the
tiny bubbles in the system have
disappeared.
k. Add brake fluid to the proper level.
WARNING
:
Check the operation of the brake after
bleeding the brake system.
To Next Page
Loading...