ADJUSTING THE FRONT AND REAR
SHOCK ABSORBERS
WARNING
:
These shock absorber assemblies contain
highly pressurized nitrogen gas, read and
understand the following information
before handling the shock absorber
assemblies.
·
Do not tamper with or attempt to open the
cylinder assemblies.
·
Do not subject the shock absorber
assemblies to an open flame or other high
heat source. This may cause the unit to
explode due to excessive gas pressure.
·
Do not deform or damage the cylinders in
any way. Cylinder damage will result in
poor damping performance.
·
Do not dispose of a damaged or worn out
shock absorber assembly yourself. Take
the shock absorber assembly to a HSUN
dealer for any service.
The spring preload, rebound damping and
compression damping forces of the front and
rear shock absorber assemblies can be
adjusted to suit the operating conditions.
NOTE:
Never turn an adjusting mechanism
beyond
the minimum and maximum settings.
To Next Page
Loading...