Hisun HS5DUTV-2 - FAULT CODE

CHASSIS
- 152-
FAULT CODE
failure code
Message
Description
4481
Handbrake Fault
Handbrake is active when direction selected.
4541
Fan Fault
No speed feedback from external heatsink fans
4542
Low Oil
Low Oil
4543
Hydraulic filter
Hydraulic Filter
4544
Pump Current Low
Pump motor is not drawing sufficient current
4545
Isolation Fault
Isolation fault detected between logic and power
frame
4546
No Motor Speed Signal
No speed feedback from motor
4547
Tow Mode
Tow mode has been activated
4548
Steer Sensor Warning
Invalid steer sensor state
4549
Pulsed Enable
Pulsed enable signal not present, unable to
enable bridge
454A
Bridge Enable Delayed
Unable to complete power on checks to allow the
bridge to enable
454B
MOSFET s/c tests waiting
MOSFET / IGBT s/c tests at power up are being
held off
454C
Electrolyte Low Level
Battery Electrolyte Low Level detected
454D
Electrolyte Cutout Level
Battery Electrolyte Low Level detected and
cutbcak
4581
Throttle Fault (Warn)
Warning level throttle fault. Used for Renault
Twizy
4582
Safety Case 1
Throttle appears to be stuck. This fault will clear
if throttle starts to work again.
4583
Safety Case 2
Throttle appears to be stuck. This fault will latch
and can only be cleared by repairing the throttle
and recycling power.
4584
Analogue Output Over Current
(warn)
Contactor driver over current
4585
Analogue Output Off with Failsafe
(warn)
Contactor driver not working
4586
Analogue Output Over
Temperature (warn)
Contactor driver over temperature
4587
Analogue Output Under Current
(warn)
Contactor driver unable to achieve current target
in current mode
4588
Analogue Output Short Circuit
(warn)
Contactor driver MOSFET short circuit detected
4589
Analogue supply (warn)
Analogue supply is >10% out of range
458A
Seat (warning)
seat regen settings applied