caused by using a scraping tool. Most of these types of products are very caustic.
Follow the gasket remover manufacturer’s instructions for use.
Thread locking Compound
A thread locking compound is a fluid applied to the threads of fasteners. After
tightening the fastener, the fluid dries and becomes a solid filler between the threads.
This makes it difficult for the fastener to work loose from vibration or hear expansion
and contraction. Some thread locking compound sparingly. Excess fluid can run into
adjoining parts.
CAUTION
Thread locking compounds are
anaerobic and will stress, crack and
attack most plastics. Use caution
when using these products in areas
where there are plastic components.
Thread locking compounds are available in a wide range of compounds for various
strength, temperature and repair applications. Follow the manufacturer’s
recommendations regarding compound selection.
BASIC TOOLS
Most of the procedures in this manual can be carried out with basic hand tools and
test equipment familiar to the home mechanic. Always use the correct tools for the job.
Keep tools organized and clean. Store them in a tool chest with related tools organized
together.
Quality tools are essential. The best are constructed of high-strength alloy steel.
These tools are light, easy to use and resistant to wear. Their working surface is devoid
of sharp edges and carefully polished. They have an easy-to-clean finish and are
comfortable to use. Quality tools are a good investment.
Some of the procedures in this manual specify special tools. In many cases the
tools is illustrated in use. Those with a large tool kit may be able to replacement.
However, in some cases, the specialized equipment or expertise may make it
impractical for the home mechanic to attempt the procedure. When necessary, such
operations are recommended to have a dealership or specialist perform the task. It
may be less expensive to have a professional perform these jobs, especially when
considering the cost of equipment.
When purchasing tools to perform the procedures covered in this manual, consider
the tool’s potential frequency of use. If a tool kit is just now being started. Consider
purchasing a basic tool set from a quality tool combinations and offer substantial
savings when complicated, specialized tools can be added.
To Next Page
Loading...