EasyManua.ls Logo

Hisun HS5DUTV-2 - Page 68

Hisun HS5DUTV-2
355 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MAINTENANCE AND ADJUSTMENT OF THE EV
68
11. Check if there is any abnormal noise during the driving.
12. Check if the maximum speed of the EV does not exceed 40km/h. EV is not allowed
to
be driven at a speed higher than 40km/h.
MAINTENCE AND ADJUSTMENT OF THE EV
To ensure trouble-free vehicle performance, it is very important to follow an
established preventive maintenance program. Meanwhile, regular maintenance can
greatly extend the service life of EV.
Regular and consistent vehicle maintenance can prevent vehicle downtime and
expensive repairing cost that could be resulted because of neglect. This will also
prevent further damage to the vehicle and avoid the possibility of injury.
If you are not eligible or technologically limited for regulated maintenance, please
contact your local distributor/dealer to perform all repairs or semiannual or annual
periodic service.
NOTE
If any problems are found during scheduled inspection or service, do not
operate the vehicle until repairs are made. Failure to make necessary
repairs could result in fire, property damage, severe personal injury, or
death.
Only trained technicians could serve or repair the vehicle and its battery
charger. The appropriate instructions must be used when performing
maintenance, service, or accessory installation.
Hot! Do not attempt to serve a hot motor.
To avoid unintentionally starting the vehicle during the process of
repairing, please disconnect the battery.
After disconnecting the batteries, wait 90 seconds for the controller
capacitors to discharge. The maintenance can be done only after this step.
To maintain the EVs or battery chargers, you must wear certified safety
glasses to protect eyes. When working nearby the battery, you must wear
face shield and rubber gloves.
When maintaining close to the electrical system or upon the electrical
system, use the insulated tools. To be more careful to avoid parts or
electrical short circuit.
Both the Periodic Service Schedule and Periodic Lubrication Schedule
must be followed to keep vehicle in optimum operating condition.
If the vehicle is constantly subjected to heavy use or used under severe
operating conditions, the frequency of the preventive maintenance
procedure should increase, compared with that recommended in the
periodic service and lubrication schedules.