Several months of non-use can cause a general deterioration of the EV, This is
especially true in areas of extreme temperature variations. This deterioration can be
minimized with careful preparation for storage. A properly stored EV is much easier to
return to service.
Storage Area Selection
When selecting a storage area, consider the following:
1. The storage area must be dry. A heated area is best, but not necessary. It should be
insulated to minimize extreme temperature variations.
2. If the building has large window areas, mask them to keep sunlight off the EV .
3. Avoid buildings in industrial areas where corrosive emissions may be present. Avoid
areas close to saltwater.
4. Consider the area’s risk of fire, theft or vandalism. Check with an insurer regarding
EV coverage while in storage.
Preparing the EV for Storage
The amount of preparation a EV should undergo before storage depends on the
expected length of non-use, storage area conditions and personal preference.
Consider the following list the minimum requirement:
1. Wash the EV thoroughly. Make sure all dirt, mud and other debris are removed.
2. Lubricate the drive chain..
3. Apply a protective substance to the plastic and rubber components. Make sure to
follow the manufacturer’s instructions for each type of product being used.
4. Place the EV on a work stand with both wheels off the ground.
5. Cover the EV with old bed sheets or something similar. Do not cover it with any plastic
material that will trap moisture.
Returning the EV to Service
The amount of service required when returning a EV to service after storage depends
on the length of non-use and storage conditions. In addition to performing the reverse
of the procedure, note the following:
1. Make sure the brakes, 加速器accelarator, 控制器controller and 电机motor stop
switch work properly before operating the EV. valuate the service intervals to
determine which areas require service.
2. If the EV has been in storage for longer than four months, 先给电动车充电charge the
battery first，and thoroughly check the battery,如果有一个或几个电池损坏，必须更
换整组电池if one or some battery are failed,must change the full set of battery。
3. 更换控制器时，在控制器和散热板之间凃“导热硅脂”When change the
controller,paste the “thermally conductive silicone grease” between the controller and
radiator plate.
To Next Page
Loading...