Need help?Do you have a question about the Hitachi Koki D 10YB and is the answer not in the manual?
General| Chuck Capacity | 1.5-10mm |
|---|---|
| Drilling Capacity in Steel | 10mm |
| Drilling Capacity in Wood | 25mm |
| Power Input | 450 W |
| No Load Speed | 0-2, 600 /min |
| Weight | 1.3kg |
| Type | Drill |
| Power Source | Corded |
| Power | 450 W |
| Chuck Size | 10 mm |
| Voltage | 220 V |
Focus on clean workspace, electrical precautions, and avoiding hazards.
Emphasizes user alertness, safety gear, proper handling, and tool maintenance.
Covers proper tool use, maintenance, and professional servicing.
Details voltage, power, speed, capacity, and weight of the angle drill.
Lists included accessories like chuck wrench and side handle.
Describes the drill's use for making holes in metal, wood, and plastics.
Ensure correct power source and that the power switch is OFF before use.
Covers extension cords, bit mounting, and side handle fixing.
Guide on selecting drill bits and confirming rotation direction.
Instructions on turning the tool on/off and locking the switch.
Guidance on drilling pressure, through-material drilling, and safety.
Use dial (Fig. 5) for non-step speed control from minimum (1) to maximum (5).
Check drill bits for wear and ensure mounting screws are tight.
Maintain motor winding, inspect and replace carbon brushes as needed.
To Next Page
