Need help?Do you have a question about the Hitachi Koki N 5008AC2 and is the answer not in the manual?
General| Brand | Hitachi Koki |
|---|---|
| Model | N 5008AC2 |
| Category | Staple Gun |
| Language | English |
Use the stapler only for driving staples into wood and similar materials.
Maintain air pressure within the rated range (70-120 psi) for safe operation.
Never use gases other than compressed air, such as CO2 or oxygen.
Avoid using the tool near flammable substances due to spark risk.
Always wear eye protection; ensure surrounding people also wear it.
Be aware of others; ensure no one is in the staple path.
Never point the staple outlet at people, even when unloaded.
Use only the specified staples as described in the instructions.
Keep finger off the trigger unless actually stapling to prevent accidental firing.
Keep hands and feet away from the firing head to prevent accidental staple impact.
Disconnect air and release pressure before removing jammed staples.
Perform checks like user presence, eye protection, and tool integrity.
Verify air pressure is between 4.9-8.3 bar (70-120 psi) and adjust as needed.
Load staples carefully, avoiding trigger/lever contact and keeping body parts away.
Drive a single staple by depressing the outlet and pulling the trigger.
Drive staples automatically by pulling the trigger and pressing the tool.
Loosen screw, adjust push lever piece up/down, tighten screw.
Remove staples, release lock lever, open blade guide, remove jam with screwdriver, close guide.
To Next Page