--- 11 ---
Item Phenomenon Possible Cause (s) Standard Countermeasure (s)
Cutting operation results in
rough cutting surfaces.
I. The workpiece is not secure-
ly fixed in position.
J. The Turn Table is not se-
curely fixed in position with the
Side Handle [116].
K. Excessive looseness or ex-
cessive tightening of the turn
connection between the Hinge
[119] and Gear Case [53].
L. Curved or rough surface of
the workpiece causes
workpiece movement during
cutting operation.
M. Excessive vibration during
cutting operation.
----
----
----
----
----
Securely fix the workpiece with
Vise (A) [79].
When performing cutting opera-
tions, securely tighten the Side
Handle [116] without fail to fix the
Turn Table in position. (The Ball
Index Settings at 0˚, 15˚, 22.5˚,
30˚ and 45˚ are affected by
vibration, and are not sufficient to
securely fix the Turn Table.)
Repair or adjust affected parts as
described in Item 1. G, above.
Plane the surface of the work-
piece to remove defects, and
recheck the cutting.
Check each of Possible Causes
A, B, D, J and K, above.
To Previous Page
Loading...
