--- 3 ---
(4) Disassembly of the Switch and Handle Section:
Tools Required:
•
Plus Screwdriver
A. When only the Switch [22] must be disassem-
bled, first loosen the two M5 x 20 -Hd.
Machine Screws [18] and M5 x 16 -Hd.
Machine Screw [16] which fix the Handle [20].
Then loosen the two M5 x 12 -Hd. Machine
Screws [27] and two D4 x 25 Tapping Screws
[35] which fix the Handle Cover [25]. The
Handle [20] can then be removed from the
Gear Case [53].
B. After loosening the D4 x 10 -Hd. Tapping
Screws [21], the Switch [22] can be separated
from the Handle [20].
(5) Disassembly of the Spindle Section and stopper Pin:
Tools Required:
•
Plus Screwdriver, Pliers, Wooden or Plastic Hammer
A. Remove the Saw Cover Ass'y [3] by following the disassem-
bly procedures in paragraph (3), above.
B. After extracting the D7 E-Type Retaining Ring [37] from the
Stopper Pin [52], the Stopper Pin [52] and Gauge Spring
[38] can be taken out.
C. After loosening the three M6 x 25 Flat Hd. Screws [74],
gently tap on the saw cover side of the Gear Case [53] to
loosen and remove the Spindle Gear Ass'y [75].
To Next Page
Loading...
