Do you have a question about the Hitachi CL-8320B and is the answer not in the manual?
Model | CL-8320B |
---|---|
Category | Hair Clipper |
Brand | Hitachi |
Power Source | Rechargeable |
Blade Material | Stainless Steel |
Charging Time | 8 hours |
Frequency | 50 Hz |
Accessories | cleaning brush, oil, comb |
Features a head that swings up to 30 degrees for easier side trimming.
Equipped with two Ni-Cd batteries for approximately 50 minutes of cordless use on a full charge.
Cutting length is adjustable to 3, 6, 9, 12mm using attachments.
Supports cordless use with 8-hour charging and AC power operation.
Blades require lubrication at a single point for maintenance.
Step-by-step instructions for charging the hair clipper unit.
Instructions for operating the unit using a direct AC power source.
Steps to prepare the clipper and blades before the first use.
Instructions for performing a standard hair cut using the clipper.
Steps for fine cutting, including thinning and adjusting the cutting plate.
Steps for preparing the floor and neck area before haircutting.
How to thin hair across the entire head for short hair.
Instructions for cutting hair on the top of the head.
How to trim hair around the ears.
Trimming the hair on the sides and edges.
Instructions for shaving fine, downy hair.
Final steps to finish and style the entire haircut.
Thinning hair on the entire head for a bob style.
Trimming the sides for a bob style.
Thinning hair on the entire head for long hair.
Shaving fine hair for long hair.
Instructions for achieving a close crop haircut.
Trimming hair around the ears for a crew cut.
Trimming the lower back hairline for a crew cut.
Trimming hair around the ears for a crew cut.
Thinning hair across the entire head for layering.
Cutting hair on the crown of the head for layering.
Techniques for layering and shaping hair.
Trimming hair around the ears for layering.
Trimming the sides for layering.
Shaving fine hair for layering.
Final finishing steps for layered hairstyles.
Use only the specified AC 220V outlet and adaptor for power.
Protect the precise cutting edge from damage by avoiding contact with hard surfaces.
Avoid pressing the cutting edge too firmly against the skin to prevent injury.
Do not use the unit in bathrooms or high-moisture areas to prevent electric shock.
Precautions for charging and storing the unit to prevent malfunction.
Store the unit safely out of reach of children.
This clipper is for human hair only; do not use on pets.
Clean and lubricate the unit after each use.
Ensure the switch is set to charging mode before performing servicing.
Use the cleaning brush to remove hair from the unit and cutting edge.
Detach the blade to clean internal hair debris.
Apply a few drops of oil to the blade for lubrication.
Store the unit in a dry location to prevent damage.