17
Operating
Searching an input signal
1.
Press SEARCH button on the remote control.
The projector will start to check its input ports in order to
nd any input signals.
When an input is found, the projector will stop searching and
display the image. If no signal is found, the projector will return to
the state selected before the operation.
COMPUTER IN 1
COMPUTER IN 2
VIDEO
S-VIDEO
COMPONENT (Y, Cb/Pb, Cr/Pr)
Selecting an input signal (continued)
1.
Press VIDEO button on the remote control.
Each time you press the button, the projector switches its input
port as below.
COMPONENT(Y, Cb/Pb, Cr/Pr)
S-VIDEO
VIDEO
● If VIDEO button is pushed to switch from a signal from
COMPUTER IN1 or 2 port, when TURN ON is selected for AUTO
SEARCH item in OPTION menu
(
40)
, the projector will check
COMPONENT port rst. If no input is detected at the port, the projector will
check the other port in above order.
Selecting an aspect ratio
1.
Press ASPECT button on the remote control.
Each time you press the button, the projector switches the
mode for aspect ratio in turn.
For a computer signal
NORMAL
4:3
16:9
SMALL
For a video signal, s-video signal or component video
signal
4:3
16:9
14:9
SMALL
For no signal
4:3 (xed)
● ASPECT button does not work when no proper signal is inputted.
● NORMAL mode keeps the original aspect ratio setting.
VIDEO
SEARCH
ASPECT
HOME
PAGE UP
PAGE DOWN
END
VIDEO
SEARCH
FREEZE
OFF
ON
MAGNIFY
ASPECT AUTO
BLANK
MUTE
VOLUME
KEYSTONE
MY BUTTON
POSITION
1 2
ESC
ENTER
MENU
RESET
COMPUTER
HOME
PAGE UP
PAGE DOWN
END
VIDEO
SEARCH
FREEZE
OFF
ON
MAGNIFY
ASPECT AUTO
BLANK
MUTE
VOLUME
KEYSTONE
MY BUTTON
POSITION
1 2
ESC
ENTER
MENU
RESET
COMPUTER
HOME
PAGE UP
PAGE DOWN
END
VIDEO
SEARCH
FREEZE
OFF
ON
MAGNIFY
ASPECT AUTO
BLANK
MUTE
VOLUME
KEYSTONE
MY BUTTON
POSITION
1 2
ESC
ENTER
MENU
RESET
COMPUTER
To Next Page
Loading...
