16
Operating
Operating
1.
Adjusting the volume
Use the VOLUME +/VOLUME - buttons to adjust the volume.
A dialog will appear on the screen to aid you in adjusting the
volume. If you do not do anything, the dialog will automatically
disappear after a few seconds.
● When
is selected for current picture input port, the volume
adjustment is disabled. Please see AUDIO SOURCE item of
AUDIO menu (
38).
● Even if the projector is in the standby state, the volume can be adjusted when
both of following conditions are satised.
- NORMAL is selected for the STANDBY MODE in the SETUP menu (
37).
- An item other than
is selected for the AUDIO OUT STANDBY of the
AUDIO SOURCE in the AUDIO menu (38).
1.
Press MUTE button on the remote control.
A dialog will appear on the screen indicating that you have
muted the sound.
To restore the sound, press the MUTE, VOLUME + or
VOLUME - button. Even if you do not do anything, the dialog
will automatically disappear after a few seconds.
Temporarily muting the sound
● When is selected for current picture input port, the sound
is always muted. Please see AUDIO SOURCE item of
AUDIO menu (38).
● C.C. (Closed Caption) is automatically activated when sound is muted and an
input signal containing C.C. is received. This function is available only when
the signal is NTSC for VIDEO or S-VIDEO, or 480i@60 for COMPUTER IN1
or COMPUTER IN2, and when AUTO is selected for DISPLAY in the C.C.
menu under the SCREEN menu (
44).
1.
Press INPUT button on the projector.
Each time you press the button, the projector switches its
input port from the current port as below.
Selecting an input signal
COMPUTER IN1 Æ COMPUTER IN2
VIDEO
Æ
S-VIDEO
(continued on next page)
VOLUME +/- button
MUTE button
● While ON is selected for AUTO SEARCH item in OPTION
menu (45), the projector will keep checking the ports in
above order repeatedly till an input signal is detected.
To Next Page
Loading...
Need help?
General