Hitachi DA-1000 - Page 8

Trouble
Cause
Indicator does not light 1. Imperfect power plug contact.
even when power switch
@ is set ON.
Door does not open even | 1. Power switch not ON.
when OPEN/CLOSE
‘| button @ is pressed.
2. Disc is rotating.
1. Insert the power plug properly into the
outlet. :
. Switch on power.
. Press STOP button (Ml) @ to stop disc
rotating.
bo —
Door stops halfway when
pressed manually.
1. By forcing the door closed, the door can
no longer be opened and closed properly.
_
. Press OPEN/CLOSE button @ and
open/close door properly.
Total track number is not
displayed even when disc
is loaded.
1. Disc has been loaded the wrong way
round.
2. Disc is dirty.
3. Disc that does not comply with ratings is
being used.
. Re-insert disc.
. Clean disc surface.
. Replace disc.
WN >
No play even when PLAY
button @ is pressed.
1. Transit screw has not been loosened.
2. Disc is dirty.
3. Scratched or warped disc.
. Loosen transit screw.
. Clean disc surface.
No sound
Distorted sound.
Certain parts of disc are
not played properly.
Proper operation stops
while a button is being
1. Pin cord not connected.
1. Improper connections with amplifier.
2. Amoplifier’s output is too high or clipped.
1. Scratches or other defects on disc.
2. Dirty disc.
1. Play position search operation no longer
corresponds with button operation.
1
2
3. Replace disc.
1
. Connect player’s output terminals and
amplifier’s input terminals with pin cord.
1. Connect player and amplifier properly.
2. Turn down amplifier’s volume.
1. Press FF button (>) @ to skip the parts.
2. Clean disc surfaces.
1. First press STOP button (ll) @ and then
resume play.
pressed.
e The only discs which can be played on
the player are those bearing the mark
on the right.
e The rotational speed of the disc may vary greatly and
a low level of sound may be heard during track
search. These are not indications of malfunctions.
e When the player is operated during FM or AM recep-
tion, the reception will be affected by noise. In cases
like this, set the player’s power switch to OFF.
e If other audio equipment is placed near the player or
if connecting cords are near, there may be a humm-
ing noise. When this happens try changing the posi-
tion of the other equipment and the cords.
e Always remove the disc whenever moving the
player. The disc may be damaged if left loaded.
® The DA-1000 has a wide dynamic range and so when
the level at the start of a track is low and the
amplifier’s volume is increased, the speaker coil may
WISE
DIGITAL AUDIO
burn out where the dynamic range is wide. Care
should therefore be exercised when turning up the
volume.
Do not take the player suddenly from a cold location
to a warm location. When a cold player is brought
suddenly into a warm room, condensation will form
on the lens and the player may not function properly.
At times like these, allow about 30 minutes for the
player to warm up.
Do
not
insert
anything
except
discs
into
the
door
and
then perform the door opening/closing operation.
This may damage the mechanism.
Do not store discs in locations exposed to high
temperature and humidity levels. The discs may
become warped and unfit for play. It may also be im-
possible to play discs with condensation on them and
so this should be wiped off with a soft, dry cloth
before play.