Do you have a question about the Hitachi DA-1000R and is the answer not in the manual?
Disc format | CD |
---|---|
Digital converter | 16-bit linear |
Frequency response | 5 Hz to 20 kHz |
Signal to Noise Ratio | 100 dB |
Channel separation | 90 dB |
Total harmonic distortion | 0.003% |
Line output | 2V |
Channels | 2 (stereo) |
Dynamic Range | 96 dB |
Output Voltage | 2V |
Prerequisites and initial checks before starting service.
Careful handling of semiconductor lasers during servicing.
Attention needed for wirings around the revolving arm.
Procedure to adjust the laser diode output level.
Steps for setting the tracking servo offset.
Method for adjusting the focus servo gain.
Procedure for adjusting turntable motor hall gain and offset.
Details on the data strobe LSI's functions and signals.
Important general guidelines for servicing the mechanism.
Critical parts that should not be disassembled.
Procedures for removing and reinstalling the door assembly.
Steps for replacing pickup drive and turntable motors.
Installation procedures for micro switches and pickup assembly.
Block diagram of the pre-amplifier section.
Block diagram illustrating the pic-up section.
Block diagram of the servo circuit section.
Component layout for the pickup printed wiring board.
Component layout for the PP printed wiring board.
Component layout for the PC printed wiring board.
Component layout for the PS printed wiring board.