-16-
Front Case [9]
Clutch Dial [4]
Click Spring [5]
Nut [6]
Spring [7]
Washer (D) [8]
Notch
2. Reassembly of the clutch unit
(a) Mount Washer (D) [8] and the Spring [7] onto the Front Case [9]. When mounting Washer (D) [8] onto the
Front Case [9], align the projection on the Front Case [9] with the notch of Washer (D) [8]. (See Fig. 4.)
(b) Mount the Nut [6] onto the Front Case [9]. (See Fig. 5.)
Align register mark (o) on the Nut [6] with the register mark on the Front Case [9]. Turn the Nut [6] about
1-1/2 turns clockwise so that register mark (∆) on the Nut [6] is aligned with the register mark on the
Front Case [9]. Check that the Y surface of the Nut [6] is aligned with the Z surface of the Front Case
[9].
Fig. 4
Fig. 5
To Next Page
