To Next PageTo Next PageWhat to do if the Hitachi H 45MEY Power Hammer LEDs light up but the motor doesn't run?
If the LEDs on your Hitachi Power Hammer display light up but the motor doesn't start, the issue might be due to internal wires not being properly connected to the Switch. Ensure all internal wires are firmly connected to the Switch. Alternatively, the Controller or the Switch itself could be broken, requiring replacement.
Why no LED of the display lamp is ON on my Hitachi Power Hammer?
If no LED is lit on the display lamp of your Hitachi Power Hammer, it could be due to several reasons. First, check the connector cable of the Panel PCB and ensure it's firmly plugged in. Also, verify that the internal wires are securely plugged into both the Controller and Filter PCB Set. If these connections are solid, the Controller, LED, or Filter PCB Set might be broken and need replacing.
What to do if one LED of the display lamp is flashing on my Hitachi H 45MEY Power Hammer?
If one LED of the display lamp is flashing on your Hitachi Power Hammer, it could be due to several reasons. Start by checking the connector cable of the Stator Sensor PCB Set to ensure it's firmly plugged in. If the connection is secure, the Stator Sensor PCB Set, Controller, or Rotor might be broken and require replacement.
Why are three LEDs of the display lamp flashing on my Hitachi H 45MEY?
If three LEDs are flashing on the display lamp of your Hitachi Power Hammer, there are a few potential causes. One possibility is a mix-up of the internal wires of the Stator Sensor PCB Set and Controller. Ensure these wires are correctly connected according to their tube colors (red, black, and white). If the wiring is correct, the Controller or Rotor might be broken and need to be replaced.
What does it mean if two LEDs of the display lamp are flashing on my Hitachi Power Hammer?
If two LEDs of the display lamp are flashing on your Hitachi Power Hammer, it is likely that the Controller is broken and needs to be replaced.
How to fix all four LEDs flashing on my Hitachi H 45MEY?
If all four LEDs of the display lamp are flashing on your Hitachi Power Hammer, the Controller is likely broken and needs to be replaced with a new one.
General| Brand | Hitachi |
|---|---|
| Model | H 45MEY |
| Category | Power Hammer |
| Language | English |
