Hitachi PC-ARFP1E - LOUVER SETTING; Individual Louver Adjustment; Louver Setting Notes

8 LOUVER SETTING
This setting is available only for the indoor unit adopting the individual louver.
The each louver angle can be set individually as following procedure.
1 Press “ ” (menu) during the normal mode (when unit is
operated). The menu will be displayed.
Menu
Motion Sensor Setting
Total Heat Exchanger SET
VENTI
Louver Open/Close
02
/
03
Louver Setting
15:10(Fri)
ENT
.R
TN.SEL.
OK
2 Select “Louver Setting” from the menu and press “OK”. The
louver setting will be displayed.
3 Select “Louver Setting” from the louver setting and press “OK”.
OK
Cancel INDV Louver SET
Louver Setting
Louver Setting
ENT
.R
TN.SEL.
4 Select the indoor unit to change the louver direction by
pressing “ ” and press “OK”.
(This screen is NOT displayed when the number of indoor unit
connected with the remote control switch is 1 (one). In this
case, (5) will be displayed).
OK
Louver Setting
01-01
01-02
01-03
Select unit to set.
01-04
ENT
.R
TN.SEL.
5 Press “ ” and select the louver direction. The selected
louver is opened and the other louvers are closed.
OK
Louver Setting:01-03
Adjust air direction & louver angle
1 2
34
ADJSEL. ENT
.R
TN.
6 Press “ ” (menu) while “?” (help) is pressed. The conrmation
screen will be displayed.
Change louver outlet number?
(2 1, 3 2, 4 3, 1 4)
Louver Outlet Setting:01-03
Yes No
SEL. ENT
.R
TN.
OK
7 Select “Yes” and press “OK”. (5) will be displayed after the
setting change is conrmed. If “No” is selected and “OK” is
pressed, the screen will return to (5).
* Regarding “Louver Setting”, the louver selected at (5) will be
set as “Nº1” and the other louver Nº will be changed clockwise
automatically as shown in the gure.
? NOTE
This “Louver Setting” is NOT available when the 2 (two) remote control switches are used in the same H-LINK (including combination with PC-ARFP1E
+ PC-LH3A (Wireless Remote Control Switch)).
LOUVER SETTING
PMML0404A rev.1.1 - 06/2022
18