Hitachi PC-ARFP1E - Swing Louver Direction; OPERATION; Operation Start

12.3 SWING LOUVER DIRECTION
1 Press “ ” (run/stop). Make sure that the operation is
started. Press “ ” or “ ” and select “LOUV”.
A/C
LOUV.
SPEED ADJTEMP
MODE SPEED TEMP
COOL
MED
Meeting Room
OK
? NOTE
For the indoor unit without the auto louver mechanism, the indication of
“LOUV.” will NOT be displayed on LCD.
2 By pressing “ ” or “ ”, the louver direction will be changed
as follows.
LCD Indication
COOL, DRY
HEAT, FAN
Auto-swing
Recommended
angle
Recommended
angle
Angle range
Angle range
: Auto swing operation will be started. At this time, the
louver will swing repeatedly on LCD.
A/C
LOUV.
SPEED ADJTEMP
MODE SPEED TEMP
COOL
MED
Meeting Room
OK
? NOTE
• The air ow angle is different for each indoor unit type. Check
Installation & Operation Manual for Indoor Unit to be used for the
detailed information.
• Louver position on LCD and the actual louver position may not match
during the auto swing operation. To x the louver positions, set the
angle after checking the position on LCD.
• The louver may NOT stop immediately right after the switch is
pressed.
13 OPERATION
13.1 OPERATION START
Press “ ” (run/stop). The run indicator will be turned on and the
operation will be started.
A/C
MODE SPEED LOUV. TEMP
COOL
MED
Meeting Room
MODE ADJLOUV.
OK
? NOTE
• Temperature/Air Flow Setting
• The setting condition will be memorized once after the setting is
conrmed, therefore the daily setting is not required. In case that the
setting change is required, refer to the “11 Operation Method” and “12
Setting Method” chapters.
OPERATION
PMML0404A rev.1.1 - 06/2022
22