!ቜϵዲϕሑϰᇥфᝐѓؖᝐӜڑڟϴ೧ąွွнą
อሲϴٖʰኜ௩־ڟٖีĄ!
)ࣇןĂϴٖڟຣݙྀ50Ƃ60° CĄ*
!࠷ϴٖ˚ઊ־Ăቜϵϴٖʰኜ௩־ڟٖีĂҏ܌ϕሑ
ᕚࢇĄ
ʮڟϫĂࡌઠ2᱕нܔڟൖဂڟٖኜϵϕሑڟʮĄ
In the following places, place a hard board of approximately
1cm thick under the refrigerator to cover the whole portion of
the bottom face.
ഒᇥປą˚ڢັ෨ώ˞Ą
˚ᇘᑆąࡳչ˞Ą
;э2dnʰĂʰߏ6dnʰ
Ą
־ąڟϴٖĄ
A location away from direct sunlight and
heat is recommended.
The floor should be sturdy and flat.
Put some kind of sturdy boarding on the floor if the refrigerator leans
to one side, in the case of carpets that may change color from heat
exposure, or flooring and vinyl chloride floor cover. (The temperature
of the floor surface may reach 50-60°C in summer.)
The refrigerator could incline on a flexible and fragile floor.
This will reduce adverse effects to refrigerating power and keep
electricity costs down.
Direct sunlight will cause discoloration to the plastic parts of the
refrigerator.
թѳѾܓʨĂఅЙྫʨڟĄ
ڢ෨ώʶఅЙఋϋอᝐѓĄ
This will reduce rusting and help keep electricity costs down.
ΥػϕሑސվѾᕠࡵܢĂϰЪૃֺಹᇥĄ࠷ࡌФവಮѾᕠَĂ܌
ቜֺ۳ФཉڟڪĄ
Ώ˛͵ΰˈി˃ĂߏʟಪಹᇥĂቜລరྲྀཉڟЊཆˈĄ
ᓶഓࠧථዩĂѮ୪ኪࡱؖڱዩԅᝐฃĞ֧֗ᐆᑻጠ්ᘞڟڪؚ
ᆇᛪğĂቜϕሑᄉᖔዩĄ
A location is not damp and has good air
flow.
A minimum of 1cm on both sides and 5cm above.
The back of the refrigerator can be placed next to a wall; but if there is a vibrating
sound or the wall color blackens (this is caused by the air around the compressor),
then move the refrigerator away.
The refrigerator releases heat in order to keep the food cold. For efficient cooling,
allow enough space around the refrigerator.
Dimension of the center part of the side of the main body is slightly larger than the
displayed dimension. Extra dimension should thus be allowed when installing the
refrigerator for better radiation efficiency.
թΡᚚĄʶթྫʨڟĄ
A refrigerator is not something that "increases the freshness" of food. At best "a brake that some degree will slow down food going bad" is a
To Next Page
Loading...
Need help?
General
