Hitachi RAC-SX10CD - Remote Controller; Names and Functions of Remote Control Unit

– 6 –
NAMES AND FUNCTIONS OF REMOTE CONTROL UNIT
REMOTE CONTROLLER
This controls the operation of the indoor unit. Signal range to reach indoor unit is about 7 meters. If
inverter lamp is used, the range of control may be shorter.
This unit can be fi xed on a wall using the fi xture provided. Before fi xing it, make sure the indoor unit
can be controlled from the remote controller.
● Transmission sign
The transmission sign blinks when a signal is sent.
● Display
This indicates the room temperature selected, timer status, function
and intensity of circulation selected.
● AIR SLEEP button
Use this button to set a comfortable air sleep temperature in the
room or start operation.
● DEHUMIDIFYING button
Use this button to dehumidify the room or start operation.
● COOLING button
Use this button to set cooling mode in the room or start operation.
● RESET button
● POWERFUL MODE buttonA
Use this button to deliver faster and more comfortable air-conditioning
or start operation.
TO
● STOP button
Press this button to stop operation only.
● ONE-TOUCH SILENT button
Use this button to set silent condition.
● FAN SPEED selector
This determines the fan speed. Each time you press this button, the
intensity of circulation will change from (AUTO) to (HI) to
(MED) to (LOW) to (SILENT).
● AUTO SWING button
Controls the angle of the horizontal air defl ector.
● TEMPERATURE button
Use this button to raise or lower the temperature setting. (Keep
pressed, and the value will change more quickly.)
● OFF-TIMER button
Select to turn OFF time.
● ON-TIMER button
Select to turn ON time.
Precautions for Use
● Do not put the remote controller in the following places.
● In direct sunlight.
● In the vicinity of a heater.
● Handle the remote controller carefully. Do not drop it on the
fl oor, and protect it from water.
● Once the outdoor unit stops, it will not restart for about 3
minutes (unless you turn the power switch off and on or unplug
the power cord and plug it in again).
This is to protect the device and does not indicate a failure.
RAS-SD10CD-SX10CD-SD13CD-SX13CD (EN1) 6RAS-SD10CD-SX10CD-SD13CD-SX13CD (EN1) 6 2/26/14 7:24 PM2/26/14 7:24 PM