1
<Cautions>
(1) If the interface circuit is faulty when power is supplied, the self-diagnosis display will not be displayed.
(2) If the indoor unit does not operate at all, check if the connecting cable is connected to the outdoor unit.
(3) To check operation again when the timer lamp is blinking, you can use the remote control for operation
(except for mode mark 1).
TROUBLESHOOTING WHEN TIMER LAMP BLINKS.
Model:
Perform troubleshooting according to the number of times the indoor timer lamp and outdoor LD301
blink.
SELF-DIAGNOSIS LIGHTING MODE
Model:
RAS_AW_063-082e
RA
RAK-
( Lights for 0.35 sec. at interval of 0.35 sec.)
K-18/25/35PSPA
18/25/35P
2
Interface voltage error
SPA
To Next Page
Loading...
