– 20 –
ATTA HING THE AIR EAN ING FI TER
1
Open the front panel.
● Pull up the front panel by holding it at both sides
with both hands.
2
Remove the fi lter.
● Push upward to release the claws and pull out the
fi lter.
3
Attaching the air cleansing fi lters to the fi lter.
● Attach the air cleansing fi lters to the frame by
gently compress its both sides and release after
insertion into fi lter frame.
4
Attach the fi lters.
● Attach the fi lters by ensuring that the surface written
“FRONT” is facing front.
● After attaching the fi lters, push the front panel at
three arrow portion as shown in fi gure and close it.
Cleaning and maintenance must be carried out only by qualifi ed service personal. Before cleaning,
stop operation and switch off the power supply.
CAUTION
CAUTION
Do not bend the air cleansing
fi lter as it may cause damage
to the structure.
NOTE
● In case of removing the air cleansing fi lters, please follow the above procedures.
● The cooling capacity is slightly weakened and the cooling speed becomes slower when the air cleansing
fi lters are used. So, set the fan speed to "HIGH" when using it in this condition.
● Air cleansing fi lters are washable and reusable up to 20 times by using vacuum cleaner or water
rinse under running tap water. Type number for this air cleansing fi lter is <SPX-CFH11>. Please use
this number for ordering when you want to renew it.
● Do not operate the air conditioner without fi lter. Dust may enter the air conditioner and fault may
occur.
!
!
RAK-25N5
RAK-35N5
RAK-50N5
(EN3) RAK-25-35-50-65N5.indd 20 11/29/10 12:27 PM
To Next Page
Loading...
