(TIME) button to set time reservation.
7. Press (TEMP
or ) button to set temperature reservation.
8. Press
(OK) button. The reservations are set. Day, program
number, ON reservation, setting temperature will light up.
will be
continuously blinks. If reservation is not complete, settings will not be
stored in memory.
To continue with the reservation, press
buttons.
Follow step 3 to 8 for reservation.
9. After all the reservations have been set, press
(SEND) button
while directing the remote controller towards the indoor unit for about 3
seconds. Timer lamp on the indoor unit will blink rapidly.
After beep sound emitted from indoor unit, TIMER lamp will light up.
Please ensure that the TIMER lamp lights up.
This indicates that the reservation has been stored in the indoor unit and
Timer function has been completed.
The reservation contents will appear on the remote controller display.
● If TIMER lamp on the indoor unit does not light up, press
(SEND)
button while directing the remote controller towards the indoor unit for
about 3 seconds.
● CAUTION ! Do not press (CANCEL) button during reservation
setting because this will result in all reservation contents to be lost.
● The reservation contents will not stored in the indoor unit until
(SEND) button has been pressed.
5
6
7
8
9
NOTE
● Up to 6 programs can be set per day. Setting ON TIMER or OFF TIMER for each program number
can be at random. When pressing
(SEND) button, the set ON TIMER or OFF TIMER for each
program number will automatically arranged so that program number 1 shall have the earliest time and
program number 6 shall have the latest time.
If the setting time is the same, Priority will be given to the latest reservation contents.
● CAUTION ! If the remote controller is left idle and
(SEND) button is not pressed within 3 minutes
after reservations have been made , all current reservations will be lost.
– 22 –
■ How to select Mode A or Mode B of WEEKLY TIMER setting.
1. Press
(WEEKLY) button. and blink on the display.
(Normally Mode A will blink fi rst).
2. Press
(WEEKLY) button again. and blink on the display.
3. Select Mode A or Mode B. Press
(SEND) button while directing
the remote controller towards the indoor unit for about 3 seconds. Timer
lamp on the indoor unit will blink rapidly.
After beep sound emitted from indoor unit, TIMER lamp will light up.
Please ensure that the TIMER lamp lights up.
This indicates that Mode A or Mode B selection and active WEEKLY
TIMER have been confi rmed.
■ Setting non-active WEEKLY TIMER .
1. Direct the remote controller towards the indoor unit and press
(CANCEL) button.
Beep sound will be emitted from indoor unit and TIMER lamp will be
OFF. Reservation indication on remote display will also disappear.
This indicates that non-active WEEKLY TIMER has been confi rmed.
● To activate back the setting of WEEKLY TIMER , repeat the steps for
"How to select Mode A or Mode B of WEEKLY TIMER setting".
NOTE
● When setting ONCE TIMER, operation of WEEKLY TIMER is interrupted. After ONCE TIMER operation
is complete, WEEKLY TIMER operation will be activated.
● When ONCE TIMER is cancelled, operation of WEEKLY TIMER is also cancelled. Need to set WEEKLY
TIMER operation for activation.
● After auto restart, WEEKLY TIMER operation is cancelled. Need to set WEEKLY TIMER operation for
activation.
To Next Page
Loading...
