Ð 0207 Ð
Ð14Ð
HOW TO SET THE SLEEP TIMER
1
Set the ON-timer.
Set the current time at first if it is not set before (see the pages for setting
the current time). Press the (SLEEP) button, and the display changes as
shown below.
Mode
Sleep timer
Indication
1 hour 2 hours 3 hours 7 hours
Sleep timer off
Sleep Timer:
The device will continue working for the designated
number of hours and then turn off.
Point the signal window of the remote controller toward the indoor
unit, and press the SLEEP button.
The timer information will be displayed on the remote controller.
The TIMER lamp lights with a beep from the indoor unit. When the
sleep timer has been set, the display indicates the turn-off time.
Example: If you set 3 hours sleep
time at 11:38 p.m., the turn-off
time is 2:38 a.m.
2
Press the (SLEEP) button and set the sleep timer.
The device will be turned off by the sleep
timer and turned on by on-timer.
How to Cancel Reservation
Point the signal window of the remote controller toward the indoor unit, and press the (CANCEL)
button.
The (RESERVED) sign goes out with a beep and the (TIMER) lamp turns off on the indoor unit.
For heating:
In this case, the device will turn off
in 2 hours (at 1:38 a.m.) and turn
on early so that the preset
temperature will be almost reached
at 6:00 next morning.
SLEEP
H
H
AM
AM
Sleep
timer
Start
H
Ð15Ð
ENGLISH
ADJUSTING THE AIR DEFLECTOR
RE SET
1
Adjustment of the conditioned air in the upward and
downward directions.
According to ÒDehumidifyingÓ or ÒCoolingÓ operation, the
horizontal air deflector is automatically set to the proper
angle suitable for each operation. The deflector can be
swung up and down and also set to the desired angle
using the Ò (AUTO SWING)Ó button. (If the angle
of the deflector is changed, it will not return to the auto-
set position after operations start unless the operation
mode is switched.)
●
If the Ò (AUTO SWING)Ó button is pressed
once, the horizontal air deflector swings up and
down. If the button is pressed again, the deflector
stops in its current position. Several seconds (about
6 seconds) may be required before the deflector
starts to move.
●
Use the horizontal air deflector within the adjusting
range shown on the right.
●
When the Ò (AUTO SWING)Ó button is
pressed while the operation is stopped, the horizontal
air deflector moves and stops at the position where
the air outlet closes.
●
When the auto swing operation is performed, if the
horizontal air deflector is moved manually, the
swinging range may drift. However, it will return to
the original operation range after a short time.
about 45û
SWINGING
RANGE
45û
about 45û
SWINGING
RANGE
45û
!
CAUTION
When operating the unit in cooling operation with the air deflector facing down and moving
automatically for a long period of time, water will condensed on the air deflector and drips down
occasionally. This will wet your furniture.
- 110 -
To Next Page
Loading...