MODE ON/OFF
FAN TURBO
TEMP
MUTE LIGHT
SLEEP
TIMER
ON
ECO IFEEL
CLOCK
CLEAN
TIMER
OFF
Each time button is pressed, the operation
mode is changed in sequence:
the "MODE"
Each time the "FAN" button is pressed, the fan speed is
changed in sequence:
16℃-30℃
Heating mode is NOT available for cooling only air conditioner.
HEATING
AUTO
COOLING
DRY
FAN ONLY
Selecting mode
FAN mode
Auto
High
Higher
Medium
Low
Lower
At "FAN ONLY" mode, only "Higher",”High”,"Medium""Low" ”Lower” are available. and
At "DRY" mode, Fan speed is set at "Auto" automatically, "FAN" button is ineffective
in this case.
Setting temperature
“－” Press once to lower temperature setting by 1℃
“＋” Press once to raise temperature setting by 1℃
Range of available set temperature
*HEATING, COOLING
Turning on
SWING, SMART, TIMER ON, TIMER OFF, CLOCK, SLEEP operation modes
will be specified in the following pages.
and SUPER
Press ON/OFF button, when the appliance receives the
signal, the RUN indicator of the indoor unit lights up.
Changing modes during operation, sometimes the unit does not response at once. Wait 3 minutes.
Wait 3 minutes before restarting the appliance.
During heating operation, air flow is not discharged at the beginning. After 2－5 minutes, the air flow will be discharged
until temperature of indoor heat exchanger rises.
Operation instructions
3
Operation modes
Note: Heating mode is NOT available for cooling only models.
3
1
2
4
Note: Press and hold “ ” button and “ ” button
together for 3 seconds will alternate the temperature display
between the ℃ and °F scale.
TEMP
To Next Page
Loading...
Need help?
General
