– 9 –
OPERATION LAMP
This lamp lights during operation.
TIMER LAMP
This lamp lights when the timer is working.
SIGNAL RECEIVER
There will be a beep sound when this receiver receives
signal from remote control.
INDOOR UNIT INDICATORS
OPERATION INDICATOR
TEMPORARY SWITCH
Use this switch to start and stop when the remote controller
does not work. [Use non-conductor stick (example
toothpick)]
● By pressing the temporary switch, the operation is done
in previously set operation mode.
● When the operation is done using the temporary switch
after the power source is turned off and turn on again,
the operation is done in automatic mode.
POWER SWITCH
RAS-
RAS-
Temporary Switch
Press
about 7mm
Non-conductor Stick
To Next Page
Loading...
