– 19 –
ENGLISH
DEUTSCHFRANÇAISITALIANOSPANISHPORTUGUÊS
∂ÏÏËÓÈο
РУССКИЙ
RAR-3R5
INTERNAL CLEANING OPERATION
Press the (FUNCTION SELECTOR) button again until
(INTERNAL CLEAN) blinks.
While (INTERNAL CLEAN) is blinking, point the remote controller
towards the unit and press the (ON/OFF) button.
• A short beep sounds and (INTERNAL CLEAN) indicator turns off
on the remote controller.
STOP
The internal cleaning operation is automatically performed after cooling, dehumidifying or Dry Cool operation
to control mold growth by configuring the (INTERNAL CLEAN) operation. (There is no mold removing
function and disinfecting/sterilizing effect.)
Press the
(FUNCTION SELECTOR) button
until (INTERNAL CLEAN) blinks.
While (INTERNAL CLEAN) is blinking, point the remote controller
towards the unit and press the (ON/OFF) button.
• A short beep sounds and (INTERNAL CLEAN) indicator turns on
at the remote controller.
• It will automatically stop after 1 hour of operation.
1
2
• Internal cleaning operation is not performed if the duration of cooling, dehumidifying or Dry Cool operation is
too short (below approximately 10 minutes).
• If the internal cleaning mode is set, the internal cleaning operation will automatically start when cooling,
dehumidifying or Dry Cool operation is stopped. During internal cleaning, the heating operation and fan
operation (with Stainless Plasma Air Purifying) are performed to control the mold growth inside the indoor
unit.
• While (ON TIMER) is set, internal cleaning operation is not performed from 2 hours before the preset
time.
• Internal cleaning operation is not performed if the air conditioner operation is stopped in any of the following
conditions below.
(Heating operation, Stainless Plasma Air Purifying operation, Quick Laundry operation and (OFF TIMER)
stop under Condensation Control operation, operation stopped by (SLEEP) button.)
To Next Page
Loading...
