Installation instructions
10
Wires Connect Steps
(1) Remove the screws, maintenance plate and the valve cover.
(2) Pass transmitting cable and power supply through the two holes on the right side plate.
(3) Fasten the conduit connection to the right side plate using the lock nut.
(4) Connect the transmitting cable and power supply to the terminal.
(5) Tie the transmitting cable and power supply with the clamp tightly.
(6) After completing the wiring, seal the wiring hole with the .putty
(7) Put the maintenance plate and the valve cover after completion of the work.
(1) Wiring distribution cover removal
Unscrew the mounting screws to remove the wiring distribution cover.
(2) Fasten the power supply cable and the transmitting cable to the conduit holder using the lock nut.
(3) Connect the power supply cable and the transmitting cable to terminal.
(4) Fasten the power supply cable and the transmitting cable with the cable clamp.
(5) Be sure to seal the holes when applying the putty.
Place the cables side to side. (Do not overlap the cables.)
(6) Put the wiring distribution cover back after completion of the work.
Lock nut
Lock nut
Conduit plate
Conduit plate
Conduit
connector
Transmitting
cable
Right side plate
Wiring
distribution
cover
Conduit
connector
Transmitting
cable
Power supply
4.0HP(36K)
1.0~3.0HP(9K~24K)
1.0~2.0HP(9K~18K)
3.0HP(24K)
Maintenance plate
Valve cover
Conduit connector for power supply
Lock nut(Qty:2)
Transmitting cable
Power supply
Right side plate
Conduit connector for
transmitting cable
Maintenance
plate
Valve cover
Right side plate
Hole
Conduit connector
Lock nut
Power supply
To Next Page
Loading...
