4. DISASSEMBLY AND ASSEMBLY FOR COMPRESSOR AND MOTOR
Removal of the motor
Step Illustration Handling instruction
5. Disassembly
of the motor
(5.0/6.0/6.5HP)
Remove the fasteners between the up
shell and the below shell on both sides of
the motor;
Remove the 2 screws fixing the
crosshead and tak
e it away from the
motor;
Take out of the motor.
Attention: The arrangement of the wire of motor
Illustration Handling instruction
Yellow line: The wire of motor.
Dotted yellow line: The wire is under
the fan shell.
Blue helix: Wire strap
During assembling, the wire of motor
should be in tension and tied by the
wire strap securely. Make sure the
upper part of wire is parallel to the
bottom as illustration. The distance
between the wire and the cover of the
electrical box should be 20mm. Make
sure the electrical box does not press
the wire.
5. Disassembly
of the motor
(3.5/4.0HP)
Take out of the motor and centrifugal
fan blade;
Remove the 2 screws fixing the
centrifugal fan blade
and get the motor.
To Next Page
Loading...
