Hitachi RAS-E10H2 - TROUBLESHOOTING TIMER LAMP BLINKS; Self-Diagnosis Lighting Mode Interpretation

No. Blinking of Timer lamp Reason for indication Possible cause
Reversing valve defective
When the indoor heat exchanger
temperature is too low in th
e
heating mode or it is too high in th
e
cooling mode.
Outdoor unit is under forced
operatio
n
Outdoor unit electrical components
defetive
When the outdoor unit is in forced
operation or balancing operatio
n
after forced operation
Indoor/outdoor interface defectiv
e
When the interface signal from th
e
outdoor
When the same error mode is detected
8 times within 30 minutes from outdoor
unit electrical components.
(However, when error is detected 8
times within two hours only for outdoor
thermistor.)
unit is interrupted.
Room thermistor or heat exchanger
thermistor is faulty
When room thermistor or heat
exchanger thermistor is opened
circuit or short circuit.
Over-current detection at the DC fan
motor
when over-current is detected at th
e
DC fan motor of the indoor unit.
IC401 or IC402 data reading erro
r
When data read from IC401 or
IC402 is incorrect
.
(1) Reversing valve defectiv
e
(2) Heat exchanger thermistor
disconnected
(only in the heating mode)
(Note)
The malfunction mode is entered th
e
3rd time this abnormal indication
appears (read every 3 minutes)
.
Electrical parts in the outdoor uni
t
(1) Indoor interface circui
t
(2) Outdoor
Outdoor unit electrical components
(For details, operate again using
remote comtroller and check from
self-diagnosis display of outdoor
unit.)
interface circuit
(1) Room thermistor
(2) Heat exchanger thermistor
(1) Indoor fan locked
(2) Indoor fan motor
IC401 or IC402 abnormal
<Cautions>
(1) If the interface circuit is faulty when power is supplied, the self-diagnosis display will not be displayed.
(2)
If the indoor unit does not operate at all, check if the connecting cable is connected to the outdoor unit.
(3) To
check operation again when the timer lamp is blinking, you can use the remote control for operation
(except for mode mark
1).
1
2
3
4
5
6
7
( Lights for 0.35 sec. at interval of 0.35 sec.)
10 times
3
times
1
time
2 times
13 times
2 sec.
2 sec.
2 sec.
2 sec.
2 sec.
1
9
times
2 sec.
(3) Indoor control P.W.B.
MODEL RAS-E10H2
MODEL RAS-E10H2
TROUBLESHOOTING WHEN TIMER LAMP BLINKS.
Perform troubleshooting according to the number of times the indoor timer lamp and outdoor LD301 blink.
SELF-DIAGNOSIS LIGHTING MODE
4 times
2 sec.
- 75
-