Hitachi RAS-E10H2 - DISASSEMBLY AND REASSEMBLY PROCEDURES (CONTINUED); Tangential Air Flow Fan and Motor Removal; Outdoor Unit Electrical Parts Removal

Indicating P.W.B.
Control P.W.B.
Support hook
未
4. T
angential air flow fan and fan motor
4. Tangential air flow fan and fan motor4. T
Fig. 5
Fig. 7
Fig. 9
Fig. 10
Fig. 1
1
Fig. 8
Fig. 6
Lower bearing cover
Cabinet
Upper bearing cover
(1) Remove two screws locking the drain pan.
(2) Press to lower the hook at the center of theunit a little and pull the
claw forward to removethe drain pan.
(5) Remove the electrical box fixing screws and GND wire fixing
screw
.
(6) Remove the terminal plate fixing screw
.
(7) Remove P
lock which binds lead wires.
(8) Set the electrical box upside down.
(9) Remove P
.W
.B. fixing screws (2 locations) and radiation fin fixing
screws (5 locations), and remove the P
.W
.B. from the support.
1. Electrical Parts
(1)
Remove the upper cover fixing screws and lift the cover to remove it.
(2) Remove the service valve cover
.
(3) Remove the terminal plate cover
.
(4) Remove the right side cover
.
(3) Remove the screws from the upper and lowerbearing covers.
(4) Remove the locking hook of the lower bearingcover from the
Cabinet.
(5) Remove two lock screws from the fan motorholder
.
(6) Pull up the evaporator by holding it at the lowerside. Insert a
screwdriver through the spacebetween the evaporator and drain
chute andloosen the fan lock screw to remove the fanand fan
motor
.
Radiation fin fixing screw
P.W.B. fixing screw
〈OUT
DOOR UNIT
〉
MODEL RAC-E10H2
- 95
-