– 10 –
FAN OPERATION
Press the selector button so that the display indicates
(FAN).
■ As the settings are stored in memory in the remote controller, you
only have to select
(FAN) then press the
button next time.
Press the button. Fan operation starts with a beep.
Press the button again to stop the operation.
START
1
2
Set the desired FAN SPEED with the button.
(the display indicates the selectable setting).
(HI) : High fan speed.
(MED) : Medium fan speed.
(LOW) : Low fan speed.
In Fan operation mode the device is function as an air circulator.
■ FAN Function
During FAN operation, compressor does not run and there is no cooling operation with only indoor fan running.
(EN2) RAS/RAC-EH10/13CKT.indd 10(EN2) RAS/RAC-EH10/13CKT.indd 10 2018-12-11 4:57 PM2018-12-11 4:57 PM
To Next Page
Loading...
