1
1
.
.
O
O
P
P
T
T
I
I
O
O
N
N
L
L
I
I
S
S
T
T
The operation modes changed in sequence:
The fan speed is changed in sequence:
FAN mode
Heating mode is NOT available for cooling only air conditioner.
At "FAN" mode, only "Auto" is not available.
At "DRY" mode, Fan speed is set at "AUTO” automatically, "FAN" button
is ineffective in this case.
Setting temperature
Turning on or off
AUTO , POWERFUL , TIMER and SLEEP operation modes will be specified
in the following pages.
Changing modes during operation, sometimes the unit does not response at once. Wait 3 minutes.
Wait 3 minutes before restarting the appliance.
During heating operation, air flow is not discharged at the beginning. After 2－5 minutes, the air flow will be discharged
until temperature of indoor heat exchanger rises.
16℃~30℃
Range of available set temperature
*HEATING, COOLING, DRY
unable to set
FAN
Note: Heating mode is NOT available for cooling only models.*
Press
Press button can change the unit operating status.
Result :
Result :
Press button once by once
Press button once by once
Auto
High
Medium
FAN
COOL
DRY
HEAT
button
Raise temperature setting by 1℃.
Lower temperature setting by 1℃.
button Press
Result :
Result :
Low
Quiet Low
PRESS
PRESS
Operation modes
�
Selecting mode
Press MODE button cancel AUTO mode.
Note: Temperature, airflow and direction are controlled automatically in AUTO mode.
AUTO mode
How to set AUTO mode?
Press the AUTO button.
Result : Enters AUTO mode (fuzzy logic operation).
Mode and fan speed are automatically
set based on the actual room temperature.
PRESS
To Next Page
Loading...
