Hitachi S Series - Page 35

– 35 –
ENGLISH
CAUTION
NOTE
!
1
2
3
4
ATTACHING THE AIR PURIFYING FILTERS
Open the front panel
● Pull up the front panel by holding it at both sides with
both hands.
Remove the Pre-fi lter
● Push upward to release the claws and pull out the
Pre-fi lter.
Attaching the air purifying fi lters
● Attach the air purifying fi lters to the frame by gently
compress its both sides and release after insertion
into Pre-fi lter frame.
Attach the Pre-fi lters
● Attach the Pre-fi lters by ensuring that the surface
written “FRONT” is facing front.
● After attaching the Pre-fi lters, push the front panel at
three arrow portions as shown in fi gure and close it.
Do not bend the air purifying
fi lter as it may cause damage to
the structure.
Please do not smell direct from
source of fi lter.
● In case of removing the air purifying fi lters, please follow the above procedures.
● The cooling capacity is slightly weakened and the cooling speed becomes slower when the air purifying
fi lters are used. So, set the fan speed to "HIGH" when using it in this condition.
● The air purifying fi lters are not washable. It is recommended to use vacuum to clean. It can be used
for 1 year. When you want to renew it, please ask your sales agent.
Type number for this air purifying fi lter is <SPX-CFH22>. Please use this number for ordering when you
want to replace it.
● Do not use detergent on the air purifying fi lter as some detergent may deteriorate the air purifying fi lter
electrostatic performance.
RAS/RAC-S50/60YHAB-EN SOFT.indd 35RAS/RAC-S50/60YHAB-EN SOFT.indd 35 2022-10-28 4:35 PM2022-10-28 4:35 PM