Hitachi SR-2004 - AM Section; Audio Section

HITACHI SR-2004
• AM SECTION
Frequency range
Sensitivity
Image rejection
IF rejection
Selectivity (IHF)
Signal-to-noise rario
Antenna
• AUDIO SECTION
Output RMS power
(Both channels driven)
Music power (IHF)
Power bandwidth
Frequency characteristics
Harmonic distortion
(at rated output)
(at '!zrated output)
Intermodulation distortion
(at rated output)
(at '!zrated output)
Input sensitivity
(at
200 W output, I kHz)
PHONO
I, PHONO 2
AUX
TAPE-I
TAPE-2
ADAPTOR
DIN
MIC
Max. input level (PHONO)
Output level
TAPE OUT
DIN OUT
Signal-to-noise ratio
(IHF, input shorted,
A-network, rated power)
PHONO
1,2
AUX
TAPE
1,2
Damping factor
Equalizer
Bass
control
Midrange control
Treble control
530 - 1,605 kHz
370llY /m (S/N 20 dB), 20llY (IHF, ext. Antenna)
70 dB
90 dB
40 dB
50 dB
Ferrite and Separate terminal
200 watts per channel, min. RMS, at 8 ohms
from 20 Hz to 20 kHz, with no more than
0.08 % total harmonic distortion.
230W/ch + 230W/ch (8 ohms, I kHz, T.H.D. 0.08%)
230W/ch
+ 230W/ch (4 ohms, 1 kHz, T.H.D. 0.1 %)
400W/ch +400W/ch (8 ohms)
10 Hz - 40 kHz
PHONO 30 Hz -
15 kHz ±0.2 dB
AUX
10 Hz - 40 kHz ±1.5 dB
Less than 0.08%
Less than 0.03%
0.08%
0.03%
2.5 mY (47 k ohms)
150 mY
(50 k ohms)
150 mY (35 k ohms)
150 mY (35 k ohms)
150 mY (35 k ohms)
450 mY (95k ohms)
3 mY (50 k ohms)
500 mY
150 mY (PHONO, AUX
at rated input)
200 mY (FM 400 Hz, 30% dev. input: 1 mY)
150 mY (AM
400 Hz, 30% mod. input: 5 mY/m)
40 mY (PHONO at rated input)
75 dB
90 dB
90 dB
75
(l kHz,8 ohms)
RIAA ±0.2 dB
±10
dB (at 50 Hz turnover frequency 150 Hz)
±10 dB (at 100 Hz turnover frequency
300 Hz)
±6 dB (at 1 kHz)
flO dB (at 10 kHz turnover frequency 3 kHz)
±I0
dB (at 20 kHz turnover frequency 6 kHz)
-2-
e
e
•